Kopel KR-8800, Руководство по эксплуатации и установке

Страница: 27 / 32

25 25
10. Pink(+) Ignition2 Sensing (Preliminary)
This wire is preliminary wire for sensing ignition2.
This wire need not connect because sense by ignition2 output when 2nd
ignition output of the connector CN 1 is normally connected.
Installation Installation
CN6 3Pin Shock Sensor Cable
Inputs shorter than 0.6 seconds will trigger the warning, while inputs longer than
0.6seconds will trigger full alarm(30 sec).
12. )Brake Sensing
This wire must be connected to the vehicle's brake light wire. This is wire that
shows (+)12V when the brake pedal is pressed. The remote start will be
disabled or shut down any time the brake pedal is pressed.
(-)Brake sensing can be used
instead of
#5 (-)Hood sensing wire of the CN 5.
11. or -)Glow Plug Sensing (Optional)
In diesel vehicles it is necessary to interface with the wire that turns on the
"wait to start light" in the dashboard. This wire illuminates the bulb until the
vehicle's glow plugs are properly heated. When the light goes out the vehicle
can be started. This wire is always available at the connector leading to the
bulb in the dashboard. It can also be found at the engine control module
(ECM) in many vehicles. However, there are some instances of diesel vehicles
without "wait to start light" wires. If this wire become (-)status when "wait to
start light" is on, you must setting to (-) jumper 2 of the main PCB.
7. Red(+)Alternator Sensing
This wire check start status of the vehicles.
Connect to the Lamp terminal of the generator.
This wire must be inputted (+) when engine of the vehicle is starting.
And this wire don't connect in case noise mode or tach pulse sensing.
8. Yellow(Tach Pulse)Enging Sensing
This wire connect to tachometer sensing wire or ignition coil(-)wire
and so on. Therefore connect to wire that pulse is outputted when engine is
operated. And this wire don't connect in case noise mode or alternator
sensing.
9. Sky Blue(-250mA)Aux2 Output (Optional)
This wire provides a (-)250mA output(1 second) whenever the transmitter
button(s) controlling Aux2 is pressed.
You can change to output time in 3-6 of the program menu.