Open Frame Monitor- 15”, 17”, 19” - User Guide Rev. 1.0
// 25
6.2.1.
Connecting the Signal Cables
To connect signal cables to the Open Frame Monitor’s connector panel, perform the following:
1.
Ensure that both the Open Frame Monitor and PC system are switched off and disconnected from the main
power supply.
2.
Connect the video cable to the required video connector (VGA, DVI or optional DP) on the connector panel.
3.
Connect the other end of the video cable to the PC system’s equivalent video connector. Tighten any connector
plugs to secure the VGA or DVI video cable.
The VGA and DVI cable not delivered with the product. To order the VGA and DVI cable, see
Table 1: Accessories.
6.2.2.
Setting up the Touch Screen (option)
To operate the Open Frame Monitor with touch functionality, perform the following:
1.
Ensure that both the Open Frame Monitor and PC system are switched off and disconnected from the main
power supply.
2.
Connect either the USB Touch Cable to the USB Type A connector (Figure 15, pos.5) or the Serial Touch Cable to
the RS 232 connector (Figure 15, pos.4).
3.
Connect the other end of the cable to the PC system’s equivalent connector.
The USB Touch Cable and Serial Touch Cable are not delivered with the product. To order the
USB Touch Cable or Serial Touch Cable, see Table 1: Accessories.
6.2.3.
Connecting to Power
Kontron recommends the use of Kontron’s PSU chosen to meet the product’s power
specification and power protection requirements, see Table 1: Accessories.
Only connect to a PSU with a rated input voltage, power cable and the external overcharge
protection that corresponds with the electrical specification on the product’s type label and
complies with the Safety Extra Low Voltage (SELV) requirements.
To connect the PSU to the Open Frame Monitor, perform the following:
1.
Connect the power cable for your region to the PSU and the other end of the power cable to the mains power
supply.
2.
For 12 VDC- Connect the power supply’s, other cable to either the DC-IN Power Jack (Figure 15, pos. 1) or the 2-pin,
12 VDC power connector (Figure 15, pos. 6) using wired DC mating power connector, see Chapter 6.4.1: Wiring the
DC Mating Power Connector.
Use only one of the 12 VDC power connectors (2-pin, 12 VDC or the DC-IN 12 VDC Jack).
