Open Frame Monitor- 15”, 17”, 19” - User Guide Rev. 1.0
// 12
1/
General Safety Instructions for IT Equipment
Read and observe the instructions within this chapter that have been compiled for user’s
safety and to ensure accordance with regulations. If the following General Safety
Instructions for IT Equipment are not observed, it could lead to injuries to the operator
and/or damage to the product. Kontron is exempt from accident liability, also during the
warranty period if the instructions within this user guide are not observed.
The product has been built and tested according to the basic safety requirements for low voltage (LVD) applications
and has left the manufacturer in safety-related, flawless condition. To maintain this condition and also to ensure safe
operation, the operator must not only observe the correct operating conditions for the product but also the following
general safety instructions:
The product must be used in accordance with the instructions for use within this user guide.
The electrical installations must correspond to the requirements of the local (country-specific) regulations.
Take care that there are no cables, particularly power cables, in areas where persons can trip over the cables.
If supplied, only use the supplied power cable.
Do not use a damaged power cable.
For DC power connection: the DC power source should be able to be switched off and switched on via an isolating
switch. The product is only completely disconnected from the DC main power source, when the DC power cable is
disconnected either, from the power source or the product. Therefore, the DC power cable and its connectors
must always remain easily accessible.
For AC power connection via external AC/DC adapter: the main power cable of the external AC/DC adapter serves
as a disconnecting device. For this reason, the outlet of the AC power source must be located near the product
and be easily accessible.
Do not place the product in direct sunlight, near heat sources or in a damp place. Make sure the product has
adequate ventilation.
Only devices and components that fulfill the requirements of an SELV circuit (Safety Extra Low Voltage) in
accordance with EN60950 may be connected to the product’s interfaces.
All plugs on the connection cables must be screwed or locked to the housing.
The product generates heat during operation, make sure it is adequately ventilated. Do not cover the air intake
and exhaust openings of the product.
Handling and operation of the product is only permitted for trained personnel within a work place that is access
controlled.
Maintenance or repair on the open product may only be carried out by trained personnel authorized by Kontron
that are aware of the associated dangers.
When accessing internal components the product must be switched off and disconnected from the power
source.
The ext. supply shall meet the criteria for SELV and <240VA acc. UL 60950-01.
