Open Frame Monitor- 15”, 17”, 19” - User Guide Rev. 1.0
// 24
6/
Installation and Starting Up
6.1.
Installation
The Open Frame Monitor is a lightweight monitor available in a variety of sizes (15”/ 17”/ 19”) and front variants
(Metal Frame/ Bezel/ 19” Rack) for easy installation in existing and new fronts.
To install, the Open Frame Monitor, perform the following:
1.
Choose screws that suit the mounting surface’s requirements.
2.
Attach to the mounting surface using the mounting brackets (Figure 4, pos.2). The minimum screw requirement is
eight screws with three screws on the top side and bottom sides (two corner mounting bracket screws and one
middle mounting bracket screw) and one screw on the right side and left side (one middle mounting bracket
screw) to secure the Open Frame Monitor, see Figure 12.
Figure 12: Mounting Screw (Minimum Requirement)
Ensure the Open Frame Monitor is properly secured to the mounting surface, do not use less
than the minimum requirement of screw and make sure the screws are located in the
specified mounting brackets, shown in Figure 12.
6.2.
Connecting the Cables
Ensure that both the Open Frame Monitor and PC system are switched off and the power
cable is properly disconnected from the power connector or main power supply before
connecting any I/O cables.
When connecting cables, following proper cabling procedures:
•
Grounding pin is connected first and disconnected last
•
Connect all I/O cables
•
Power connection is the last connection
