KISS 4U V3 SKX – Preliminary Rev. 0.6
www.kontron.com
// 45
8.2.
Removing the Handle Brackets
The two handles brackets are removable. To remove the two handles brackets, proceed as follows:
1.
Loosen and the remove the two screws (Figure 9, pos. 4) that fasten the handle brackets (left side, right side)
and retain for later use.
2.
Remove the handle bracket and store with the screws retained in step 1.
3.
To reinstall the handle brackets proceed in the reverse order.
The KISS 4U V3 SKX platform is delivered with the handle brackets already assembled.
8.3.
Removing the Front Access Panel and Front Access Panel Side-Plates
The front access panel and the two front access panel side-plates are removable.
Figure 31: Front Access Panel Side-plate and Handle Bracket
1.
Bracket handle
2.
Front access panel side-plate
To remove the front access panel and front access side-plates, proceed as follows:
1.
Remove the handle brackets as described in Chapter 8.2: Removing the Handle Brackets (steps 1-2) and retain
the handle bracket and screws for later use.
2.
Loosen the two screws that hold the front access panel side-plates to the chassis (left side, right side).
3.
When the front access panel side-plates are loosened enough the front access panels can be released from the
hinges (Figure 11, pos. 16) on the right side and then the left side.
4.
Lift the front access panel away while carefully guiding the front access panel’s holder arm out of holding slot
(Figure 10, pos. 1).
5.
Store the front access panel for future use.
6.
Tighten the front panel side-plate screws loosened in step 2 to reinstall the front access panel side-plates, or
disassemble the front panel side-plates by removing the front access panel side-plate screws loosened in
step 2
7.
If required install the handle bracket as described in Chapter 8.2: Removing the Handle Brackets.
1
2
