KISS 4U V3 SKX – Preliminary Rev. 0.6
www.kontron.com
// 42
To install short expansion cards (half length), only the card hold down bracket for short
expansion cards must be removed.
Figure 30: Step to Remove the Card Hold Down Brackets
4.
Loosen the internal fastening screw (Figure 30, step 1) and then the externally accessible fastening screw
(Figure 30, step 2) that secure the short card hold down bracket. Pull the card hold down bracket to the left
(Figure 30, step 3) to detach the card hold down bracket from the sideways mounted internal bolts (Figure 20,
pos. 4). Lift the card hold down bracket upwards (Figure 30, step 4) to remove. Retain the short card hold down
bracket and two screws for later use.
5.
Loosen the internal fastening screw (Figure 30, step 5) and then the externally accessible fastening screw that
secure the retaining bracket (Figure 30, step 6). Lift the retaining bracket upwards (Figure 30, step 7) to remove.
Retain the retaining bracket and two screws for later use.
6.
Loosen the internal fastening screw (Figure 30, step 8) and then the externally accessible fastening screw
(Figure 30, step 9) that secure the long card hold down bracket. Pull the card hold down bracket to the left
(Figure 30, step 10), to detach the card hold down bracket from the sideways mounted internal bolts (Figure 20,
pos. 6). Lift the card hold down bracket upwards (Figure 30, step 11) to remove. Retain the long card hold down
bracket and two screws for later use.
7.
Install/remove the expansion card into/out of the mainboard expansion slot and fasten the slot bracket or the
expansion card bracket to the rear side slot. To improve stability, use the supplied holding clamp and screws, see
Table 2: Accessories and Spares Parts to secure the expansion card to the card hold down brackets.
7
2
3
4
1
6
8
11
10
9
5
