KISS 4U V3 SKX – Preliminary Rev. 0.6
www.kontron.com
// 33
4.4.
Cover
Energy hazards-240 VA present inside the chassis!
Before removing the KISS 4U V3 SKX’s cover, ensure that: the system is switched off and
disconnected from the mains power supply.
Activities such as work inside the system, system expansion with expansion cards, or
maintenance must be performed by qualified personnel aware of the associated dangers!.
The KISS 4U V3 SKX’s is only properly closed if the cover is attached and the cover’s knurled
screws are securely fastened:
•
Cover fastening screw (Figure 10, pos. 12) on the front side
•
Two knurled screws (Figure 16, pos. 5) on the rear side
The cover fastens to the chassis using a knurled screw on the front side (Figure 22, pos. 3), and two knurled screw on
the cover’s rear side (Figure 22, pos. 6). For information on how to open the cover, see Chapter 7.1: Opening and
Closing the Cover.
Figure 22: Cover Underside
1
Underside of cover
2
Cover front side
3
Angled centering fixing bracket with
tapped hole (on front side)
4
Fixing bracket (on front side)
5
Cover rear side
6
2x knurled screws (on rear side)
6
5
1
3
4
2
