Kontron cPCI-MXS64GX, Техническое справочное руководство

Страница: 63 / 135

Installing the Board
3.19
3.3.4. Supervision Features
The cPCI-MXS64GX provides a set of programmable I/O registers to setup the Intel PIIX4
(I/O addresses 4030h to 4037h) and the XILINX FPGA (I/O addresses programmable at
190h-193h, 290h-293h or 390h-393h using the AWARD Chipset Features Setup).
Only register bits needed to program the power fail detection and watchdog functions are
described below.
3.3.4.1. Power Fail Monitoring
The power failure detector status can be readout from one bit of the system register located
at the address 4031h (See table below). The detection conforms to the following conditions
(* = active low signal):
It always monitors the +5V power supply. When it drops below 4.65V (typical), the system
is reset.
It can monitor the onboard battery. When the battery is in a low condition (below 2.9V
typical), the PFO* (power fail output) signal goes low. The status of the PFO* signal can
be read at I/O address 4031h, bit 1 (0 = failed, 1 = good). An interrupt handler can then
service the interrupt. If you choose not to generate an NMI, you can use an algorithm to
detect a low battery condition and respond accordingly.
Register Bit # Function Software Programming
4030h
0-7 Reserved Reserved
4031h
0, 2-7 Reserved Reserved
1 Power Fail Output (Internal/External
Battery or External Power Source) Read: 0 = Failed, 1 = Good
4032h 0, 2-7 Reserved Reserved
1 Watchdog Stage 1 Status Read: 0 = Timed out, 1 = Normal
4034h 0-7 Reserved Reserved
4035h 0-1, 4-7 Reserved Reserved
2 Watchdog enable Write: 1 = Disable, 0 = Enable
3 Watchdog reset Write: 1-0-1 (toggle) to activate
the watchdog (when enabled)
4036h
0-7 Reserved Reserved
4037h 0-7 Reserved Reserved
For more information, contact the Technical Support department