![Kontron coolMonster/PM Скачать руководство пользователя страница 42](http://html1.mh-extra.com/html/kontron/coolmonster-pm/coolmonster-pm_user-manual_1996256042.webp)
18 17BFeature Interface
Kontron User's Guide
coolMonster/PM
42
18
17B
Feature Interface
18.1
82B
Connector
The feature connector is available through the X12 connector (26 pins) and controls functions such as
the PS/2 keyboard clock and data, hard-disk LED, USB serial bus ports, and various ATX power signals.
The following table shows the pin-out of the connector.
Pin Signal
Name
Function Pin Signal
Name
Function
1
KBCLK
PS/2 Keyboard clock
2
MSCLK
PS/2 Mouse clock
3
KBDAT
PS/2 Keyboard data
4
MSDAT
PS/2 Mouse data
5
VCC *
+5V
6
NC
For internal use only!
7
NC
For internal use only!
8
GND
Ground
9
H_LED
Hard-disk LED
10
NC
For internal use only!
11
NC
For internal use only!
12
SPEAKER
Speaker out
13
NC
For internal use only!
14
NC
For internal use only!
15 GND
Ground
16 RESIN
Reset
input
17
NC
For internal use only!
18
NC
For internal use only!
19
5V_SB
ATX standby supply
20
LILED
Link integrity LED
21
PS-ON
ATX power on signal
22
SPEEDLED
Speed LED
23
PWRBTN
ATX power button
24
ACTLED
Activity LED
25
USB2-
Universal serial bus port 2 (-)
26
USB2+
Universal serial bus port 2 (+)
Notes
: (*) To protect the external power lines of peripheral devices, make sure that:
-- the wires have the right diameter to withstand the maximum available current
-- the enclosure of the peripheral device fulfils the fire-protecting requirements of IEC/EN 60950.
The current of the pins on this connector is limited to 0.5A.
18.2
83B
Configuration
You cannot configure the Feature interface from the BIOS Setup Utility.
18.3
84B
Signal Description
223B
KBCLK/KBDAT/MSCLK/MSDAT
®
Keyboard and PS/2 mouse data and clock signal.
Do not use the keyboard and the mouse signals at the same time as the signals on the
front bracket.
224B
H_LED (Hard-disk LED)
®
Signal shows activity on primary and secondary IDE drive. Connect the cathode of the
LED to the H_LED pin and the anode of the LED to the VCC supply voltage pin. The
required 470R resistor is already mounted on board of the coolMONSTER/VC and
coolMONSTER/VE.
Содержание coolMonster/PM
Страница 1: ...Kontron User s Guide coolMonster PM Document Revision 1 13...
Страница 2: ......
Страница 80: ...26 25BAppendix C Block Diagram Kontron User s Guide coolMonster PM 80 26 25BAppendix C Block Diagram...
Страница 83: ...28 27BAppendix E Connector Layout Kontron User s Guide coolMonster PM 83 28 2 116BBottom Side...