Konsberg Simrad PX MultiSensor Mk2, Инструкция по эксплуатации

Страница: 31 / 42

454200/A
29
Checking if the sensor charges properly
Every PX family sensor is equipped with a custom made Li-Ion battery. The PX
MultiSensor Charger is especially designed for charging this battery.
Procedure
1 Make sure that the ambient temperature is between 0 and +45°C (+32 to +113°F).
If you try to charge the sensor in ambient temperatures below 0°C (32 °F), an
internal safety mechanism will prevent the charging.
2 Verify that the sensor sockets are clean and dry, and that salt residues and moisture
have been removed.
3 Connect the 3–pin charger plug to the sockets at the end of the sensor body.
4 Connect the charger to a mains power
outlet (100 to 230 Vac).
5 Observe that a small lamp close to the
sockets on the sensor is lit, indicating
that the charger is correctly connected.
If no lamp is lit, try to move or keep
the PX MultiSensor charger upside
while connected to the sensor.
6 Verify that the lamp flashes every four
seconds to indicate that the charging
is in process.
7 Observe that the indicator lamp on the
charger is lit with a
red colour.
This means that fast charging is in
progress.
If you connect the charger to a fully charged sensor the indicator lamp on the
charger will be
red for a short period, and then it will change to Green .
Further requirements
If your sensor does not take charge, repeat the procedure with a different PX MultiSensor
Charger.
Related topics
Troubleshooting, page 36
Use and maintenance, page 23
Use and maintenance