19
Controlling external motors
If case you need to start or stop external equipment (such as a cutter) before starting or stopping the blower, there
is a possibility of time delay.
The blower control´s digital outputs allows for control of up to 3 external motors.
Setup of delay at start/stop
Delay
(x sec.)
Delay
(x sec.)
Start / stop blower
Motor starts after blower
and stops before blower
Motor starts before blower
and stops after blower
Delay
(y sec.)
Delay
(y sec.)
In case of replacement of the AC drive, new data is read by selecting
Motor Data - Read Drive Size - Transfer to Drive
In case it is not possible to read drive size, the AC drive has not been set
up to communicate via Profinet.
Menus
Next
and
Previous
are used by Kongskilde, and can not be ope-
rated by
Admin
The delay (in sec.) is entered, and below is set if the external motor shall
start/stop before or after the blower wll start/stop.
No motor
Motor starts after blower and stops before blower
Motor starts before blower and stops after blower
