Kongsberg EM 2040 MKII, Руководство по установке

Страница: 39 / 248

472405/A
39
• The use of a baffle between the propellers and the transducer may reduce noise
appreciably.
• Static discharges caused by the rotating propeller shaft may be removed by proper
grounding or by mounting a coal brush from the shaft to vessel ground.
Reducing rattle noise
Ensure that no parts near the transducers can rattle as a result of water flow or vibrations.
Reducing interference
Interference from the transmission pulses from other hydroacoustic instruments on
board the vessel is difficult to avoid. The problem may be reduced by choosing the
working frequencies carefully and to some extent by separating the different transducers.
On vessels with a large number of separate hydroacoustic systems installed and in
simultaneous use, a separate synchronizing system (for example the K-Sync) should
be considered.
Reducing electrical noise
• Make sure that all units are properly grounded. This is important to avoid electrical
noise.
• Use shielded cables with correct grounding.
• Separate the cables used by the EM 2040 MKII system from other cables with high
voltages, large currents or transients.
• Place all high voltage power cables in metal conduits.
Preparing the installation