Kongsberg EM 2040 MKII, Руководство по установке

Страница: 50 / 248

50
472405/A
For more information, see:
Where to install the transducer, page 28
2 Determine the installation principle.
The decision must be based on:
• The vessel drawings
• The shape and properties of the hull
For more information, see:
Transducer installation principles, page 40
3 Design, manufacture and mount the equipment required for the transducer
installation principle.We recommend using KM designed mounting plates or pods
whenever possible.
353631 Transducer mounting plate - 0.7 x 0.7 degrees, page 180
355913 Transducer mounting plate - 0.4 x 0.7 degrees, page 181
Note
The risk of galvanic corrosion must be taken into account in the design of the
mounting structure. Periodic inspection of the mounting screws and use of
sacrificial anodes will be required in a permanent installation.
4 Mount the transducers.
5 Do a dimensional survey to determine the necessary position and angle
measurements of the transducer and the relevant sensors.
The information provided by the dimensional survey is entered into the EM 2040
MKII software as installation parameters.
For more information, see:
Dimensional surveying and alignment, page 150
6 Lay the transducer cables from the transducers to the Processing Unit.
7 If your vessel will operate in waters with a lot of marine growth, consider applying
a thin layer of anti-fouling paint to the transducer face.
Marine growth (biological fouling) on the transducer face reduces the performance.
We recommend that you paint the transducer face immediately after installation,
and then again as often as required to maintain the protection.
For more information, see:
Painting the transducer face, page 69
Approved anti-fouling paints, page 71
KONGSBERG EM 2040 MKII Installation Manual