Komatsu PC18MR-3, Руководство по эксплуатации и техническому обслуживанию

Страница: 116 / 284

INSTRUMENTS AND CONTROLS
114 WEAM012101
Closing the cab floor
IMPORTANT
q
Before closing the cab floor, check that there is no damage
or anomaly in the wiring or piping located in the compart-
ment under the floor. If any damage or anomaly is ob-
served, have the necessary repairs carried out by your
Komatsu Distributor.
1. Remove the safety pin (10) and store it into the apposite hole
(13).
NOTE
q
If the safety pin (10) does not come out, try again by pushing
the handle (6) at the same time.
2. Pull the cab floor release lever (5) in the direction shown by
the arrow and at the same time pull the handle (6) down-
wards in the direction indicated by the arrow (approximately
45°).
IMPORTANT
q
Lower the cab floor slowly and make sure that the wires
and pipes located under it are neither damaged nor twist-
ed.
q
When tilting or closing the cab floor, be extremely careful,
and keep away from the area under the cab floor.
3. Tighten the cab floor fastening screws (3) applying the re-
quired torque.
Tightening torque: 156.8 to 196 Nm
NOTE
q
If any screw is damaged, replace it with an original Komatsu
part having the same size.
4. Close the engine hood (2).
RKA22780