Kolpa Kolpa-san Series, Инструкция по установке и эксплуатации

Страница: 31 / 98

Bathtub masage systems page 30
ENGLISH www.kolpasan.eu
is in stand-by mode, waiting for the Whirlpool pump to activate.
The function can be switched off by pressing the OZONE button for 2 seconds
(long press).
WATER HEATER function:
If you press the HEATER button with enough water prresent, LED4 and LED5 will
start blinking for 7 seconds, to indicate that it will be possible to change the set
temperature by pressing SETTING (+/-) button. The display will show the setting
temperature
»tXXC«
with XX being the temperature. You can set temperature
ranging from 25°C to 40°C with steps of 1°C. Once reached 40 °C, the next press
of the SETTING button will return to the minimum value of 25°C.
The first time from GENERAL OFF, the system starts at a standard temperature of
36°C –
»t36C«.
7 seconds after the last press of SETTING button, LED5 will switch off, while LED4
will remain switched on and fixed. If Whirlpool pump is off, it will be automatically
activated.
When Whirlpool function is switched off, because of 20 minute time-out or by
pressing WHIRLPOOL button, the heating will go into stand-by mode for 5
minutes, after that time if the water temperature is below the set temperature, the
Heater and the Whirlpool pump (and Ozone if activated) will all automatically
activate. The heater also resumes from 5 min stand-by if the HEATER button is
pressed.
If you press the HEATER button for 2 seconds you can deactivate this function. If
at this time the Whirlpool function is active, the Whirlpool function (water pump) will
remain active.
WARNING: After the Heating function has been deactivated
– LED4 will be
blinking (stand-by mode) or LED4 will be OFF (deactivated), the whirlpool pump
will continue to work for 10 seconds to allow the water heater to cool down. If the
stand-by mode was activated by pressing the WHIRLPOOL button, the pump will
continue to cool the heater for only 2 seconds before it stopps.
WARNING: Water heater is most effective when all the water jets are turned
DOWN INTO THE WATER, and the air regulator for the water jets is CLOSED
–
WHEN NO AIR IS COMMING FROM THE WATER JETS
– ONLY WATER.
CHROMOTHERAPY function (color light):
If you press CROMO button in any situation (even without enough water),
Chromotherapy function is activated. Underwater light will switch on with WHITE
COLOR light and both LED6 and LED5 will start blinking for 7 seconds, to indicate
that it will be possible to change colour by pressing the SETTING button. The
display will show the number of the selected colour among the 8 possible colours
»Co 1«, »Co 2«, … »Co 8«:
WHITE, RED, YELLOW, ORANGE, GREEN, LIGHT
BLUE, DARK BLUE, VIOLET.
If you continue pressing the SETTING button after colour 8, you can choose one of