Kolpa Kolpa-san Series, Инструкция по установке и эксплуатации

Страница: 18 / 98

Bathtub masage systems page 17
ENGLISH www.kolpasan.eu
ADITIONAL OPTION +microjets
This includes 6 -8 aditional micro (small) water
jets, positioned for back massage. With
integrated diverter it is possible to adjust the flow
of water for these jets, as shown in th picture 4.
MASSAGE BATHTUB CLEANING AND MAINTENANCE
- THESE INSTRUCTIONS APPLY TO ALL MASSAGE SYSTEMS -
o
Children may not perform unsupervised cleaning or maintenance work on the product.
o
After the completed massage cycle, the bathtub should be rinsed off with a jet of
clean water, and particles that might clog the openings in the massage jet nozzle
should be removed. The chromium-covered parts should be wiped off with a clean
cloth.
o
We recommend using the KOLPA SAN DISINFECTANT to disinfect the massage
system.
Fill the bathtub with water so that it reaches just slightly above the jet nozzles, and
turn the massage jet nozzles downwards.
Pour the measured amount of the disinfectant into the water. Turn on the water
massage system and let it run for 2 or 3 minutes. Leave the water the bathtub for at
least 5 more minutes before draining it. For a more thorough cleaning, we
recommend leaving the water with the disinfectant in the bathtub for 6 to 12 hours.
Rinse the bathtub, including the massage system pipes, thoroughly with clean water.
The easiest way to rinse out the massage system pipes is to fill the bathtub with clean
water and turn on the massage pumps. Repeat the procedure until clean water flows
from the massage jet nozzles.
o
If necessary, the cleaning with the disinfectant may be repeated several times.
o
Please use only liquid cleaning agents and a soft cloth. To clean other acrylic
surfaces and remove limescale, we recommend the KOLPA SAN SPECIAL
CLEANING AGENT.
Spray the special cleaning agent on the surface or apply it with a sponge, and leave it
for a while to take effect. Rinse with clean water. For high-gloss fittings, we
recommend wiping the surface.
o
To remove limescale, you may also use vinegar normally used in households, which
is more effective if heated.
o
Using abrasive cleaning agents with rough particles is not recommended.
o
Do not use oils, bath products, honey, flowers etc. in the water massage bathtub, as
they may clog the engine and the water jet nozzles.
o
We recommend cleaning the mechanical filter with a special cleaning agent every two
weeks or at least once a month, and CHANGING the insert (filter) every two months
when the water is CONSTANTLY in the massage bathtub.