www.kolidainstrument.com
140
6
）
Press Ang. to measure the angle again.
Ang.
REC/Angle
*ZA 45°18′23″
*HAR 87°23′09″
Pt K2010
REC. Ang. AUTO
7) Press ESC to restore the “Record Mode Screen.”
ESC
Record（1/2）
1.Stn Data
2. Back Sight data
3. Angle data
4. Dist data
5. Coord data
6. Dist+Coord data
·
Perform angle measurement and record automatically by pressing a single key: AUTO.
When this key is used, it is unnecessary to perform angle measurement in MEAS Mode. Press
AUTO on the “Record Mode Screen” to perform angle measurement and automatically record the
results. When this is done, the point number automatically increases one from the last number. After
measurement has been completed, the results are display for 2 seconds and the screen displayed
before AUTO was pressed is restored.
21.4 Recording Distance Measurement Data
·
It is possible to record the most recently measured distance measurement data in a JOB. And it is
possible to perform and record distance measurements, offset measurements, etc. under Record
Mode.
·
Once the data has been recorded, REC will not be displayed in order to prevent double recording.
·
It is convenient to use AUTO to perform automatic operation from distance measurement to
recording.
·
The items recorded are slope distance, vertical angle, horizontal angle, point number, codes, and
target height.
Operating Procedure
Operation
Display
1) Press F2 REC from the third page of MEAS
mode. (or press REC key from keyboard direcly)
REC
Record（1/2）
1.Stn Data
2. Back Sight data
3. Angle data
4. Dist data
5. Coord data
6. Dist+Coord data
