TF.16 IFU StarDevice.003.10-EN 2021-01-12
prepared by Pulavskyi A., Kolyesnik O.
15
They are used for medium to
large joints and muscle
correction and treatment
They are used for correction
and treatment of medium and
large joints, and muscles.
They are used for correction
and treatment of large joints,
and muscles.
5.4
HOW TO HOLD THE MANIPULATOR
Hold the manipulator in either hand or in the holder. Do not allow the manipulator to be
on the floor!
An angle of application
The manipulator must be applied at an angle of 43 ° to the spine
during the correction of the vertebral segments - this angle excludes
the load and injury of the facet joint. In all other cases, the angle of
application is chosen by the doctor at his own discretion, based on the
tasks assigned.
Stabilization of the tip
It is also necessary to stabilize the tip to prevent it from slipping and to prevent the stretching of the tissues
during the correction procedure in addition to observing the angle of inclination.
Stabilization is performed by using three fingers of the left hand (if the doctor works with his right
hand):
1.
The index finger should be placed on the spinous process of the vertebra.
2.
To put the middle and thumb on the top of the tip in the place where the rubber caps are attached
to the metal part of the tip. Do not press down the metal part of the correction tip. Do not put your
fingers in front of the tip or on the upper tips of the rubber caps of the tip.
The angle of the manipulator application is 90 ° when correcting other anatomical areas.
