-20-
Fig. 22
Fig. 23
Fig. 24
• Put the Pin Wheel
[28]
in the Nose
[18]
. Facing the notch of the Pin Wheel
[28]
to Blade Guide (A)
[86]
,
push the Piston Ass'y
[16]
down to the bottom dead point without meshing with the eight Needle Rollers
D4
[33]
and Needle Roller D4.5
[24]
as shown in Fig. 22.
• Mount the Chamber Base Ass’y
[11]
, Special Nut M58
[13]
, and Nose
[18]
to the Cylinder
[5]
in this order.
Apply Three-Bond TB1342H adhesive in the form of a line circling around the Cylinder
[5]
two times as
shown in Fig. 23. Then mount the Special Nut M58
[13]
.
• Mount Sensor Ass’y (B)
[39]
using a round bar of 2 to 2.5 mm in diameter as shown in Fig. 24 to protect
the root of the wire from being applied force. After mounting Sensor Ass’y (B)
[39]
, remove the round bar.
Round bar
(Remove it after mounting Sensor Ass’y (B)
[39]
.)
Apply TB1342H adhesive here (2 places).
[13]
[18]
Notch of the Pin Wheel
[28]
[16]
[18]
[86]
M58 th
rea
ded
po
rtion
