Kohler Sterling 7104 Series, Руководство по установке

Страница: 11 / 44

6. Cut Holes for Valves and Spout
For Baths with Wall Surrounds Only
Cut holes for the spout and valve handles in the plumbing end wall. Refer to the manufacturer’s
instructions for required hole sizes. Verify that the escutcheon, flange, or cover plate is large enough
to cover the hole for the component.
IMPORTANT! Risk of product damage. Determine whether your saw blade cuts on the pull or push
stroke. Failure to follow directions regarding your blade’s cutting direction may damage the end wall’s
finish.
If you are using a saw blade that cuts on the pull stroke, remove the end wall. Determine and
mark locations for the valve and shower controls on the unfinished side (back side) of the end wall.
If you are using a saw blade that cuts on the push stroke, determine and mark locations for the
valve and shower controls on the finished side (front side) of the end wall. When completed,
remove the end wall.
Drill 1/4
″
(6 mm) pilot holes at the marked locations.
With a saw, carefully cut the fitting holes to the correct diameter.
Carefully clean any debris from the bath to reduce the risk of surface damage.
2. Drill pilot holes. 3. Cut holes.
1. Mark center of
valves and spout.
Sterling 11 1015404-2-D