Kohler Ricochet K-14280-C6-0, Руководство по установке и эксплуатации

Страница: 7 / 16

Install the Lavatory (cont.)
Waterproof any exposed areas of wood.
For Marble/Stone Countertops
Position the countertop upside down on foam padding to protect the surface.
Mark and drill 3/8
″
holes 5/8
″
(1.6 cm) deep at the locations shown on the
template.
Using a setting tool and hammer, secure the anchors.
For All Installations
If the countertop has not been installed, install it at this time.
Drill the faucet holes according to the faucet installation instructions.
Install the faucet and drain according to the manufacturer’s instructions.
NOTE: Do not use adhesives or adhesive sealants with this product. Only use
silicone sealant.
Apply a continuous bead of silicone sealant to the top surface of the lavatory rim
where it will contact the countertop.
For Marble/Stone Countertops: Install the lavatory to the countertop with the
clamps and anchor screws provided.
For Wood Countertops:
Install the lavatory to the countertop with the clamps and
wood screws provided.
For Other Countertop Materials: Refer to the countertop manufacturer’s
instructions for recommended fasteners.
NOTICE: Risk of product damage. Do not overtighten the clamps. Overtightening
may cause irreparable damage to the lavatory.
Position the lavatory squarely under the cutout before tightening the clamps.
Draw the lavatory rim up against the countertop until it is snug. Do not
overtighten.
Immediately wipe away any excess sealant and fill any voids as needed. Allow
the sealant to set for 30 minutes before proceeding.
Connect and tighten the trap to the drain. Complete the water supply connections
to the faucet according to the instructions packed with the faucet.
Run water into the lavatory and check for leaks.
Installer le lavabo
Découper l’ouverture du comptoir en suivant avec précaution la ligne tracée du
gabarit. Placer le lavabo dans la découpe et vérifier l’ajustage.
REMARQUE: Utiliser les vis et les ancrages fournis pour comptoirs d’une épaisseur
minimale de 1
″
(2,5 cm). Utiliser des ancrages et des fixations (non-fournis) pour des
comptoirs plus minces.
Pour des comptoirs en bois
Marquer et percer les trous pilotes des vis à bois aux emplacements illustrés sur le
gabarit.
Kohler Co. 7 1068257-2-H