Kohler Lombardini LDW FOCS 502 Euro 2, Руководство по обслуживанию

Страница: 74 / 98

74
D
C
L
H
L
115
116
117
7
Service Manual LDW FOCS 502 automotive _ cod. ED0053027270 - 3° ed_rev. 02
7.6.4 Assembling the speed governor and flow limiter
Important
• Make sure that all components are perfectly clean
and dry.
• Check that all components are intact and, if
necessary, replace them with original spares.
1. Mount the levers (
C
) and pivot them with the screw (
D
)
to a torque of 0.70 Nm.
2. Install the flow limiter.
3. Mount the rotation components onto the camshaft.
Important
• The rotation components are produced in several
versions. Consult the diagram when mounting.
1. Mount the weights assembly ( H ) onto the camshaft.
2. Carry out this operation with the weights open so that
they close on the flat part of the spacing collar.
3. Check that all the components of the cover ( L ) are
intact and, if necessary, replace them with original
spares.
Important
• Make sure that the contact surfaces are perfectly
intact and clean.
3. Mount the new O-ring on the cover ( L ).
4. Mount the cover ( L ) and fasten the screws without
tightening them.
5. Tighten the screws in an alternating pattern to a final
torque of 10 Nm.
Important
• Check that the camshaft has no axial clearance.
flow
limiter
hose
hose
Governor counterweight
entire support
INSTALLATION OF ASSEMBLIES