Kohler K-2515, Руководство по установке

Страница: 8 / 36

5. Install the Lavatory
Install the faucet to the lavatory following the faucet
manufacturer’s instructions.
Properly seat the lavatory on top of the vanity. The back of the
lavatory must be flush against the finished wall.
Push down on each corner of the lavatory to make sure it does
not rock from side to side on the vanity.
NOTICE:
The lavatory must be level before proceeding. If
adjustment is needed, remove the lavatory and set it aside. Use a
screwdriver to turn the levelers located at each top corner of the
vanity. Seat the lavatory on the vanity. Recheck for level.
Remove the lavatory from the vanity and set it aside.
NOTICE: Siliconized acrylic caulk must be used to secure the
lavatory to the vanity. Do not use 100% silicone sealant, which will
damage the finish of the vanity.
Apply a 1/8
″
(3 mm) thick bead of siliconized acrylic caulk
around the top edge of the vanity.
Carefully position the lavatory on top of the vanity.
Apply a small bead of siliconized acrylic caulk to the top edge
where the lavatory contacts the wall. Allow the caulk to dry
before proceeding. Refer to the manufacturer’s instructions for
recommended drying time.
Connect the drain and supplies.
Leveler
Apply sealant.
1082745-2-A 8 Kohler Co.