Operating Instructions (cont.)
After approximately 20 minutes of continuous operation, a built-in timer will automatically stop the
pump/motor.
Chromatherapy Light Operation
If the chromatherapy lights are turned off, press the light control switch (located opposite of the
pump control switch). The chromatherapy lights will begin to cycle through each of the colors
(sweep mode). The light control switch flashes blue in the sweep mode.
If desired, press the light control switch to lock in one constant color. The light control switch is a
constant blue in this mode.
Press the light control button to turn the chromatherapy lights off.
Care and Cleaning
For best results, keep the following in mind when caring for your KOHLER product:
•
Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
•
Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
•
Do not allow cleaners to soak on surfaces.
•
Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
For
detailed
cleaning
information
and
products
to
consider,
contact
the
KOHLER
Customer
Care
Center
at
0-800-4-KOHLER
(0-800-4-4537)
or
visit
www.kohler.com.br.
Flush
System
NOTE
:
Flush
your
whirlpool
system
twice
a
month
or
more,
depending
upon
usage.
Make sure the metal suction screen is clean and placed correctly over the plastic suction cover.
Fill the bathing well with hot water so the bathing well overflows the bathing well rim and flows
into the overflow channel to the drain overflow, and so both overflow channel sensors are
completely covered with water. The green light in the pump control switch will start to blink
automatically within 30 seconds after the overflow channel sensors are completely submerged.
Add 10 mL of a low-foaming dishwasher detergent, and 590 mL (20 ounces) of household bleach to
the water.
Press the pump control switch button, and let the unit run for 5 to 10 minutes.
Press the pump control switch button a second time to turn off the unit.
Completely drain the unit.
Wipe the surface dry with a clean, soft cloth.
Troubleshooting
NOTICE
:
This
section
is
for
general
aid
only.
A
Kohler
Co.
Authorized
Service
Representative
or
qualified
electrician
should
correct
any
electrical
problems.
For
warranty
service,
call
0-800-4-KOHLER.
NOTE
:
The
product
model
number
is
printed
on
a
label
on
the
pump
side
of
the
whirlpool.
NOTE
:
For
service
parts
information,
visit
your
product
page
at
www.kohler.com.br.
1019731-BR5-A
English
-4
Kohler Co.
