Operating Instructions
Please spend a few minutes reading these operating instructions before using this product.
Basic Operation
Remove all loose bathing items (such as soap bars, shampoo bottles, and washcloths) from inside
the unit.
NOTE
:
Do
not
use
excessive
amounts
of
shampoo
or
soap
while
you
are
operating
the
overflowing
bath.
Of
course,
you
can
freely
use
shampoo
and
soap
for
showering
before
you
fill
the
unit.
Make sure the metal suction screen is clean and placed correctly over the plastic suction cover.
Close the drain.
NOTE
:
The
water
temperature
in
the
bath
should
not
exceed
40°C
(104°F).
The
in-line
heater
will
automatically
turn
off
as
the
water
temperature
approaches
40°C
(104°F)
and
will
remain
off
until
the
water
cools.
NOTE
:
The
in-line
heater
will
help
maintain
the
water
temperature
while
your
overflowing
bath
is
running.
Always
fill
the
unit
with
water
tempered
to
your
desired
comfort
level.
Fill the unit with water to a level where the overflow channel sensors are completely covered and
the water in the bathing well runs into the overflow channel drain.
Within 30 seconds after the overflow channel sensors are submerged, the green light on the pump
control switch will automatically start to blink. This indicates the pump/motor is ready to begin
operation.
Fill the unit 102 mm (4
″
) to 152 mm (6
″
) above the bathing well rim.
NOTE
:
Like
any
other
bath,
prevent
flooding
the
area
around
the
unit
by
entering
the
filled
bathing
well
slowly.
This
will
allow
the
system
to
properly
drain
excess
water.
NOTE
:
Exercise
caution
if
you
walk
or
move
around
in
the
bathing
well.
Plastic
surfaces
are
inherently
slippery
when
wet.
Slowly enter the bathing well, then press the pump control switch to start the pump/motor and
begin operation.
As the pump/motor turns on and water begins to circulate, the green light on the pump control
switch will change to solid green and will stay on as long as the overflowing bath is running.
Press the pump control switch again to turn off the overflowing bath. The green light in the pump
control switch will automatically start to blink until the overflowing bath is drained below the
overflow channel sensors, or is restarted.
Water
Overflow
Channel
Sensors
Overflow
Channel Drain
Pump Control
Switch
Kohler Co.
English
-3
1019731-BR5-A
