Before You Begin
3-1/2"
(89 mm)
18-1/4"
(464 mm)
1-1/16"
(27 mm)
1-9/16" (40 mm)
4-1/2"
(114 mm)
9-3/8" (238 mm)
5-13/16" (148 mm)
8-1/4" (210 mm)
9-1/4"
(235 mm)
20-3/8"
(518 mm)
19-13/16"
(503 mm)
7/8"
(22 mm)
1-11/16" (43 mm)
5-5/16"
(135 mm)
2"
(51 mm)
3"
(76 mm)
CAUTION: Risk of product damage. Do not apply excessive heat near the valve or apply flux or acids directly onto
the valve. This valve contains plastic and rubber components that will melt if heat is directly applied.
IMPORTANT: Read these instructions and determine the locations for all required components before beginning
installation.
This valve is not intended for single-outlet use unless pairing two outlets for a high flow bath filler.
For optimum performance, dedicated water supply lines are recommended.
If the water supply is a significant distance from the valve, it is recommended that the water supply tube size be increased
to offset the piping loss. If necessary, review with your Plumbing Professional.
If possible, install the valve before installing the digital control(s).
A qualified electrician should install a 230 V RCD electrical outlet, within the stud framing, above the valve.
If possible, install the electrical outlet before installing the valve.
All installations shall comply with the Water Supply (Water Fittings) Regulations 1999, Water Supply (Water Fittings)
Regulations (Northern Ireland) 2009, and The Water Supply (Water Fittings) (Scotland) Bylaws 2014.
Safe and easy access to the product should be available at all times.
When installing the product in an area not regularly accessed, consideration for potential leaks must be taken into
account. While such events are unlikely, it is advisable to periodically check the installation for traces of water on or
around the product.
1430528-W2-
A
10
Kohler Co.
