Kohler 15RES, Руководство пользователя

Страница: 14 / 36

TP-6344 4/09 14 Section 2 Operation
2.3 Exercising Generator Set
Operate the generator set under load once each week
for 20 minutes.
The operator should perform all of the prestart checks
before starting the exercise procedure.
Start the
generator set according to the starting procedure in the
controller section of this manual. While the generator
set is operating, listen for a smooth-running engine and
visually inspect the generator set for fluid or exhaust
leaks.
2.4 Advanced Digital Control
Operation
Figure 2-1 illustrates the user interface on the Advanced
Digital Control (ADC 2100).
Note: Have setup and adjustments of the ADC 2100
performed only by an authorized distributor/
dealer. The setup and adjustments are password
protected.
2.4.1 Controls and Indicators
Figure 2-2 describes the controls and indicators located
on the controller. The LED display indicates generator set
status as shown in Figure 2-2. The display is active when
the master switch is in the RUN or AUTO position and
remains active until the generator set master switch is
moved to the OFF/RESET position or the power to the
controller is removed.
Depending on the controller
configuration, the LED display may turn off after a period of
inactivity when the master switch is in AUTO. See Section
2.4.6.
The buttons on the controller keypad are used only for
system configuration and adjustment. The ADC 2100 is
factory-set and should not require configuration or
adjustment under normal operating conditions. If the
generator set is reconnected to a different voltage and/
or frequency, refer to an authorized Kohler distributor/
dealer
for system configuration and adjustment
instructions.
GM28707A-C
1. LED display
2. Up and down arrow buttons
(use for setup and adjustment only)
3. Generator set master switch
4. Select button (use for setup and adjustment only)
1
4
3
2
Figure 2-1 ADC 2100 Controls
Control or Indicator Item Description
LED display
Runtime hours Displays total generator set runtime hours.
Crank indication Displays CC_1, CC_2, or CC_3 to indicate the first, second or third attempt to
start the engine. The last digit flashes during the crank cycle rest periods.
Fault codes Flashes a 2- or 3-letter fault code to indicate various fault conditions. See
Section 2.4.4.
Software
version See the generator set installation manual.
Keypad Select and
arrow buttons The keypad is used for controller setup and adjustment only. Have setup and
adjustments performed only by an authorized Kohler distributor/dealer. The
setup and adjustment functions are password-protected.
Generator set master
switch (RUN-OFF/
RESET-AUTO) Three-position
switch Switch functions as the generator set operation and controller reset switch.
Figure 2-2 ADC 2100 Controls and Indicators