Koden MDC-2240, Руководство по эксплуатации

Страница: 35 / 129

MDC-2200/2500 Series Chapter 3 Basic operation
0093125002-04 3-11
5
The interval between lines can be varied by pressing and rotating [VRM2] knob.
In “Normal” setting, variable range is min: equal to Range ring one, max: 50% of selected range.
In “1 – 7” setting, min: 0, max: about 1.6 times of selected range.
Bearing can be varied by pressing and rotating [EBL2] knob.
Clockwise Counter clockwise
EBL knob
PI
040.0° 3.000NM
PI RE L
Refer to “Measure distance and bearing between 2 points (Offset)” (page 3-13) for offsetting
center of Parallel index line to optional position (cross cursor position).
(For MDC-2500)
1 Setting of number of lines to be displayed
Press [MENU] key to display “Menu”.
To proceed [MARKER] => [PARALLEL INDEX] and select number of lines then press [ENT]
key
NAV
ALARM
CHART
DATADISP
STARTUP
ECHO
RANGE RINGS
BRG TRUE/REL
CURSOR
NORMAL
MARKER
Move to
the right
PARALLEL INDEX
1
2
3
4
5
6
7
ATA/EPA MARKER SEL**
**
：
MARKER SEL is provided for MDC-2200 series onl
* : Displayed at installation of AIS unit (optional).
AIS*
Move to
the right
y.
In Normal, line number is equal to Range ring one.
Designated number of PI is displayed when 1 – 7 value is selected.
2
PI is displayed by pressing [VRM2] knob.
Bearing is displayed by figure on middle lower left of the screen, and distance between PI lines
is displayed on middle lower right of the screen during PI display.
PI lamp in lower left of [VRM] knob is lighted during PI display.
Push
VRM knob
PI
000.0° 3.000NM
PI RE L