Koden MDC-2200 series, Руководство по установке

Страница: 76 / 123

Chapter 5 Detailed setup and additional menu MDC-2200/2500 Series
5-14 0092625002-06
5.1.4.4 Block number
This is used to select the block number for Alarm2 operation.
Alarm area blockings are effective to identify individual alarm natures such as the place, time, etc.
Setting : 1 to 20
No block operation is possible unless registered in this item.
5.1.4.5 Block clear
This is used to clear registered “BLOCK NO”.
Setting : CANCEL, CLEAR
To clear each point in the area shall be done by “Setup latitude and longitude input”.
5.1.4.6 Detection
This is used to select alarm detection methods for the blocks set in “BLOACK NO”.
Setting mapping : OFF, IN, OUT
In case of “OFF” mode, it can be used for the mapping.
5.1.4.7 Detection level
This is used for signal level setting of target to be detected for the blocks set in “BLOCK NO”.
Larger value and higher signal level, the targets become stronger.
Setting : 1 to 7
In case of the setting is too small, it reacts noise, too.
In case of the setting is too higher, it does not react weaker targets.
5.1.4.8 Latitude and longitude input
This is used to ser points for the area setting in the block registered in “BLOCK NO”.
Setting value : Latitude, Longitude, Divided, Delete
Divide : In order to divide into multiple (up to 16) ranges, a division is set to “ON” after specification
of the last point of a range. Multiple areas (up to 16) can be divided in 1 block. It can be completed
when the last point in a area sets divide “ON”.
Since Alarm2 is to set the alarm area, Min.3 points shall be set.
Remarks : In case of Alarm2 display “OFF” or “BLOCK NO” between input “BLOCK NO” and
current “BLOCK NO” being different, Lat-Long does not indicate.