Koden MDC-2200 series, Руководство по установке

Страница: 42 / 123

MDC-2200/2500 Series Chapter 3 Method of installation
0092625002-06 3-19
3.5.3 Connecting the Display unit to GPS Compass (KGC-1)
When using the GPS Compass (KGC-1), connect the J6 port of the
D
isplay unit to DATA2
connector of KGC-1. This connection allows high data speed.
The
procedure
to
Switch to high-speed communication mode
(1) Press [MENU] key to display “Menu”.
(2) Place a cursor on DATA DISP and move the joystick to the right to display the sub-menu.
(3) Place the cursor on PROTECT CANCEL and press [ENTER] key. “Menu” display will
disappear.
(4) Press [MENU] key to display “Menu”.
(5) Place the cursor on I/O, move the joystick to the right, select HDG => KGC-1 SET =>
INITIAL, place the cursor on START and then press [ENTER] key. The communication baud
rate is set to 38400 bps for both Display unit and KGC-1. Start the KGC-1 to output HDT,
GGA, VTG, and ZDA signals.
NOTE: The KGC-1 DATA2 port (connecting port to radar) is set as 38400 bps, signal duration 50
ms, signal type: HDT, GCA, VTG, and ZDA by this initialization. When this DATA2 port is used for
another device that cannot handle this baud setting, connect this device to DATA1 port or do not
perform initialization.
Display unit MRD-101/102
J1 J2 J3
J4 J5 J6
Monitor &
Buzzer
AIS Remote
J7
KGC-1
Figure 3.19 Cable connection between Display unit and KGC-1