MDC-1840BB/1841BB/1860BB/1810BB/1820BB Series Chapter 5
Operation Manual
Basic Operation
0093142122-10
5-13
(5) Move 1st VRM to touch the right front of the second target. The distance between
the two targets will be shown on the bottom right center of the screen.
Figure 5.3 Measuring the distance between two points
5.5.12 Picture off-centering
The radar picture can be offset to any position within 2/3 of the screen radius. Use the
following procedure.
(1) Move the cross cursor to a desired point to be offset.
(2) Press the OFF CENTER key. The entire radar picture will be moved to the
specified
point.
(3) A further press of the key will reset the picture to the center position.
5.5.13 Selection of presentation mode
The following four kinds of presentation modes are available.
(1) Head Up, Relative Motion
(2) North Up, Relative Motion (Note: Bearing information must be provided)
(3) Course Up, Relative Motion (Note: Bearing information must be provided)
(4) True Motion (Note: The bearing and speed information must be provided)
To select the presentation mode, press the MODE key. Every press of the key will
change the presentation mode in the above sequence.
Target 1
Target 2
EBL
REL
20.0
o
VRM
3.00
Target 1
Target 2
NM
CURSOR REL
110.0
o
2.000 NM
The cursor position
data is shown here
1st EBL
1st VRM
1st VRM
1st EBL
