Koden KRD-10, Руководство по эксплуатации, Страница: 76 / 130

Chapter 4 Setup Procedure KRD-10
4-10 0093170212-01
In the case of DECCA
4.3.5 Compensating the compass
The course and bearing to waypoint is shown in true bearing. You can adjust the GNSS true bearing to
the magnetic compass bearing.
(Automatic compensation)
In the Auto mode, the magnetic compass is compensated based on the built-in global magnetic
variation maps. However, avoid using this mode if you are higher than 75 degrees North or South
latitude. The compass may have a small error because the system contains world maps. Manual
correction is recommended. For areas that do not allow exact translation of a true bearing to a
magnetic bearing, despite the map covering the whole world, the resulting value may differ from the
actual deviation.
(1) Press key until Menu options 1 to 9 appears.
(2) Press
key to select “
4: Compensation
”.
(3) Press
key to select “
4: Magnetic variation
”.
(4) Press [ ] or [ ] key to move cursor onto
“
Auto
”.
(5) Press key.
Initial setup: AUTO
(Manual compensation)
(4) Press [ ] or [ ] key to move cursor onto
“
Manual
”.
(5) Press key.
(6) Press key to change the correction offset.
(7) Enter a (4-digit) compensation offset by numeric keys.
(8) To correct to (-), move the cursor to the "+/-" place and press the " " key.
4/W
ENT
ENT
ENT
MENU
4/W