28
A-61167 April 2005
Cleaning the paper path
1. Remove the wrapping from the Transport Cleaning Sheet.
2. Adjust the paper feeder guides to fit the cleaning sheet.
3. Feed the cleaning sheet (adhesive side up) through the scanner in portrait
orientation until all residue is removed from the drive rollers.
4. Adjust the feeder guides to fit, then feed the cleaning sheet (adhesive side
up) through the scanner in landscape orientation until all residue is
removed from the drive rollers.
5. Using the same cleaning sheet, repeat Steps 3 and 4, but feed the
cleaning sheet through the scanner with the adhesive side down until all
residue is removed from the drive rollers.
NOTE: When a cleaning sheet gets very dirty, discard it and use a new one.
Replacing parts
Customer-replacement parts (feed module, separator module, pre-separation
pad, roller tires, and installation instructions) are available in the following kits:
Use only these replacement parts in your scanner.
The expected life of customer-replaceable parts is shown below.
•
Kodak
Separator Module for i200 Series Scanners:
200,000 document pages
•
Kodak
Feed Module for i200 Series Scanners:
500,000 document pages
NOTES: The composition of the tire materials was engineered to provide the
ultimate in feeding reliability across the broadest range of document
types, sizes, and thicknesses. Expected life figures are offered as
guidelines for operations that follow the recommended scanner
cleaning procedures in this section and that scan document types
within the recommended paper types (refer to “Preparing documents
for scanning” in the
Introduction
section).
Your experience may vary. Certain paper types (such as carbonless
paper or newsprint), failure to clean regularly, and/or use of non-
recommended cleaning solvents can shorten tire life.
Tire life may be reduced due to a long transport timeout setting.
To order replacement parts, refer to Appendix B,
Supplies
and Accessories
.
Item
CAT No.
Kodak
Feeder Consumables Kit for i200 Series Scanners (1
complete feed module, 1 complete separator module, 2 pre-
separation pads, 24 tires)
124 1066
Kodak
Extra-Large Feeder Consumables Kit for i200 Series
Scanners (5 complete feed modules, 5 complete separator
modules, 10 pre-separation pads, 120 tires)
821 5808
Kodak
Imaging Guide Set (1 upper, 1 lower)
120 0278
