Setting Up Your Printer
32
www.kodak.com/go/aiosupport
Switching the printer connection type
You can change the way you connect to your All-in-One printer at any time.
For Windows
USB to Wi-Fi
To convert the USB connection from a PC to a wireless network connection:
1. Disconnect the printer from the computer.
2. Use the Windows Control Panel to delete the printer from you computer.
3. Configure the wireless network from the printer front panel. See
Configuring a
wireless network connection, page 25
.
4. Press
Menu
.
5. Press
until
Network Settings
is selected, and then press
OK
.
6. Select
View Network Configuration
and confirm you have an IP address.
7. Run the Kodak Printer Network Setup Utility. This is located on the
Start > All
Programs > Kodak > Kodak Printer Network Setup Utility.
8. Select
Connect via Network - Wireless / Wi-Fi
, then click
Next
to proceed. The
printer should be detected and driver installations begin. If you have more than
one printer connected to your network, select the printer and then click
Next
.
9. After the driver installation completes, click
Done
to proceed.
10. The printer will be named Kodak ESP9-XXXX, where XXXX is a number unique
to your printer.
USB to Ethernet
To convert the USB connection from a PC to an Ethernet connection:
1. Disconnect the printer from the computer.
2. Use the Windows Control Panel to delete the printer from your computer.
3. Connect the printer to the network (LAN port on Router) with an Ethernet cable
4. Run the Kodak Printer Network Setup Utility. This is located on the
Start > All
Programs > Kodak > Kodak Printer Network Setup Utility
.
5. Select
Connect via Network - Ethernet cable
, then click
Next
to proceed. The
printer should be detected and driver installations begin. If you have more than
one printer connected to your network, select the printer and then click
Next
.
6. After the driver installation completes, click
Done
to proceed.
7. The printer will be named Kodak ESP9-XXXX, where XXXX is a number unique
to your printer.