ADJUSTMENTS
12
WARNING
To avoid injury from unexpected starting or
electrical shock, make sure the trigger is released and
remove the power cord from the power source.
BEVEL STOP ADJUSTMENT (FIG. P, Q)
90° Bevel Adjustment (Fig. P)
1. Loosen bevel lock handle (1) and tilt the cutting arm
completely to the right. Tighten the bevel lock handle.
Lower blade.
2. Place a combination square (2) on the miter table with the
ruler against the table and the heel of the square against
the saw blade.
3. If the blade is not 90° square with the miter table, loosen
the bevel lock handle, tilt the cutting head completely to
the left, loosen the locknut (4) on the bevel angle
adjustment bolt (3) and use a 13 mm wrench to adjust the
bolt (3) in or out to increase or decrease the bevel angle.
4. Tilt the cutting arm back to the right at 90° bevel and
recheck for alignment.
5. Repeat steps 1 through 4 if further adjustment is needed.
6. Tighten bevel lock handle (1) and locknut (4) when
alignment is achieved.
90° Bevel Indicator (Fig. Q)
1. When the blade is exactly 90° to the table, loosen the bevel
indicator screw (5) using a #2 Phillips screwdriver.
2. Adjust bevel indicator (6) to the “0” mark (7) on the bevel
scale and retighten the screw.
45° Bevel Adjustment (Fig. Q)
1. Unlock the bevel lock handle (1) and tilt the cutting arm as
far to the left as possible.
2. Using a combination square, check to see if the blade angle
is 45° to the table.
3. If the blade is not at 45° to the miter table, tilt the cutting
arm to the right, loosen the locknut (8) on the bevel angle
adjustment bolt (9) and use a 13 mm wrench to adjust the
bolt (9) in or out to increase or decrease the bevel angle.
4. Tilt the cutting arm to the left to 45° bevel and recheck
for alignment.
5. Repeat steps 1 through 4 until the blade is at 45° to the
miter table.
6. Tighten bevel lock handle (1) and locknut (8) when
alignment is achieved.
TURNING LASER GUIDE ON (FIG. R)
1. To turn laser on, press on/off rocker switch (1) to
“ON” position.
2. To turn laser off, press on/off rocker switch (1) to
“OFF” position.
Fig. O
Fig. P
Fig. Q
Fig. R
1
2
3
4
1
2
9
8
1
7
6
5
1