KME DAP 26, Руководство пользователя

Страница: 14 / 52

Depending to the setting of the parameters a dynamic processing of the input
material will occur when the audio signal level exceeds the adjusted threshold
value. The gain reduction works corresponding to the selected algorithm
(compressor or limiter). The limiter works with a ratio of infinite:1 what means
that the input level may be theoretically be increased by any value without a
change in the output level which can be specified using the threshold and gain
slider.
The knee value describes the shape of the regulation curve. A knee value of 0
means a hard compression / limiting (the processing starts immediately after
exceeding the threshold level), a higher knee value describes a curve which is
more soft and sounds normally better depending on the program material.
The attack/release time draw the speed of the gain regulation mechanism. A
longer attack time will let some signal peaks pass which may sound more
powerful, a short attack time will give more protection to the speakers.
A longer release time is advantageous for maximum protection of speaker
components, on the other hand a short release time increases the average
sound level (using the compressor algorithm).
Noisegate
Channel [1 … 6]
Type [Bypass; Gate On]
Threshold [-85 dB … -35 dB]
Close [1 ms … 1000 ms]
Hold [1ms … 10000 ms]
Noise gate of the output. Due to the setting of threshold level the noise gate
can be used for gating disturbing background noise or even audio sources of
low level. Just set the threshold to the level you want to gate – set a hold time
(the processor “waits” this time before fading out the audio signal) and a close
time (length of the fade-out itself). When the audio level is above the threshold
again, it is faded in quickly and automatically!