KMC Controls KMD-5210, Инструкция по установке и эксплуатации

Страница: 36 / 38

KMC Controls
Revision E
Configuration and programming
Programming for BACnet in WinControl XL
36
Programming for
BACnet in
WinControl XL
The LAN Controller supports the BACnet object types listed in Table 4-4.
Program the LAN Controller as would other KMD series controllers. Observe
the following details when programing an interface to a BACnet internetwork:
◆
Only inputs, outputs and variables within the LAN Controller appear as
objects in a device on the BACnet internetwork.
◆
A point configured as a KMD digital point will appear as a BACnet
binary object. Analog points appear as analog objects.
◆
To be visible as an object to BACnet devices or operator workstation,
configure the KMD point with both a description and a label in
WinControlXL Plus. In TotalControl configure the point with both a
description and name.
◆
Use BAC-SET, BAC-GET and BAC-RLQ in Control Basic to read and
write other objects on other BACnet devices.
KMC Controls recommends that all BACnet services have adequate error
handling protocols within your control program. A sample Control Basic code
segment is provided below to demonstrate reading the state of Binary Input 8
in a BACnet device with instance number 1.
Example:
250 G = BAC-GET( 1 , BI8 ) : REM BACnet read
260 ON-ERROR 280 : REM If error, bad read, don’t use it
270 1-VAR16 = G : REM Read was good, use the value.
280 WAIT 0:00:15 : REM Release so other CB programs can
run
290 END
Table 4-4 Supported BACnet object types
Mnemonic Object type
AI Analog Input
AO Analog Output
BI Binary Input
BO Binary Output
AV Analog Value
BV Binary Value