KMC Controls KMD-5210, Инструкция по установке и эксплуатации

Страница: 18 / 38

KMC Controls
Revision E
Installation
BACnet networks
18
Note
The controller with only one EIA–485 cable connected is normally the
end-of-line. This is also the controller where the cable shield ground is tied to
earth or a chassis ground
.
BACnet networks
The KMD-5210 LAN Controller supports an optional Class 3 Conformance
Level of the BACnet specification. The BACnet protocol is implemented using
either one or the other of the following network configurations.
◆
Ethernet 802.3 specification in KMD-5210-001
◆ MS/TP EIA–485 in KMD-5210—002.
See the section
Programming for BACnet in WinControl XL
on page 36 for details on
BACnet features.
Note
The BACnet options are licensed for each controller. To upgrade a KMD-5210
controller to BACnet, contact KMC Controls for license information.
BACnet 802.3
The KMD-5210–001, the BACnet 802.3 version of the LAN controller, connects
to the LAN in the same manner as the standard LAN controller. See
Network
connections
on page 14 .
The BACnet internetwork most likely will use one or more BACnet routers to
manage the BACnet internetwork and devices. The KMD-5210–001 must be
connected to the same Ethernet broadcast domain segment as at least one
BACnet router and the router must be enabled for BACnet 802.3 traffic. To
configure a KMD-5210–002 for network connections, see
BACnet configuration
on page 35 .
Illustration 2-6 End-of-line termination jumper sample for a Tier 1 network
Install jumpers Remove jumpers
Install jumpers