KMC Controls KMD-5210, Инструкция по установке и эксплуатации

Страница: 24 / 38

KMC Controls
Revision E
Installation
Connecting to a Computer
24
3. Verify the configuration switches on the back of the modem are in the
correct position for the firmware in the controller.
4. Use HCM to initialize Computer Port B for modem operation.
Connecting a KMD-5210 to an Ethernet LAN
To connect a PC to the controller via the Ethernet, the PC a must have a valid
IP address on the Ethernet network that connects to the controller and install
the PC on the Ethernet. Refer to the section
Configuring a controller with HCM
on
page 32 for additional information.
Direct Serial Port Connection
Two RS-232 ports are provided on the controller for connecting a PC directly
to the controller. Connect the PC to the controller using a KMD–5672 PC to
Controller cable. Refer to Illustration 2-12.
Table 2-1 Configuration switches: Firmware 4.0 and later
1 2 3 4 5 6 7 8
Up Up Down Down Down Up Up Down
Table 2-2 Configuration switches: Firmware earlier than 4.0
1 2 3 4 5 6 7 8
Up Up Down Down Up Up Up Down
Illustration 2-12 PC-controller cable connection
Pin 2–Red
Pin 3–Black
Pin 5–Green
Red–Transmit
Ground–-Green
Black–Recieve
KMD–5672