KMC Controls KMD-5210, Инструкция по установке и эксплуатации

Страница: 32 / 38

KMC Controls
Revision E
Configuration and programming
Configuring a controller with HCM
32
Configuring a
controller with
HCM
Before placing a controller into service, it must be initialized and addressed
with the KMC
Hardware Configuration Manager
(HCM) software. HCM is
distributed with application programs; complete instructions for HCM are
included in the
H ardware Configuration Manager
manual and the context sensitive
help system built into HCM.
Caution
The Hardware Configuration Manager sets all controllers on the Tier 2
network to the same parameters. To prevent disruption to other controllers on
the network, disconnect the network cables or remove the isolation bulbs on
the controller prior to starting HCM.
1. Start HCM, connect the controller to the computer and establish
communications with the controller.
2. Make the entries as described in the section KMC digital network
configuration on page 33 .
3. Setup the Ethernet routing table. See Ethernet routing table on page 34 .
4. If applicable, enter BACnet parameters. See BACnet configuration on
page 35 .
5. Cycle the power to the controller. The controller can now be connected to
a network and additional programming can be performed with
WinControl XL or the Acuity Configuration tool.
Note
Ethernet settings do not take effect in a controller until the power is cycled.