KlinMak ILav65, Инструкция по эксплуатации

Страница: 10 / 46

ILav65 Instruction Manual
2. MACHINE DESCRIPTION
ILav65 is a Scrubber-Dryer machine, driven by an operator seated on board, to wash and
dry hard floors, battery powered, intended for commercial use.
The main systems of the machine are as follows:

The detergent solution tank and relevant circuit,

The washing brushes plate

The dirty water recovery tank and relevant circuit

The electrical system and relevant control panel, the steering and speed device.
The function of the detergent solution tank is to store water (with dilution of any
detergent), supplying it to the washing system.
The relevant system includes the tank, filter, proportional valve to adjust flow rate and
controls.
The tank contains the detergent solution (water and detergent) and supplies it to the
washing system when required. The filter protects the solenoid valve from debris and
dirt contained in the water. The proportional solenoid valve controls detergent solution
supply to the washing system. The valve automatically prevents the flow of the
detergent solution. The control selector of the solution flow - by controlling opening
duration and section of the solenoid valve - regulates the amount of detergent solution
conveyed to the washing system.
The disc washing device includes: two counter-rotating disc brushes, the electric motor,
the actuator to lift the entire brush unit, the manual cam for lifting the wiper only and
the controls. The brushes wash the floor while the motor and the pair of gears, solidly
attached to the brushes, actuate their motion. The side band, in bristles, lets the detergent
solution remain in the brushes' working area.
The wiper (or squeegee) is the water collecting device.
The water flow is regulated by a proportional solenoid valve (from 0 to 3.5
litres/minute), there is also the option of mixing the water with the chemical detergent,
contained in the relevant bottle. The mixture percentage is set by a peristaltic pump
which regulates the detergent flow, conveying it and mixing it downstream of the
proportional solenoid valve (in the version with Ki-Do device).
The function of the recovery device (wiper or squeegee) is to suck the dirty water and
convey it to the recovery tank.
The recovery system includes: the wiper, the vacuum turbine, the filter, the recovery
tank and the controls. The wiper collects the dirty detergent solution from the floor as
the machine moves forward. The vacuum turbine assures the necessary vacuum to suck
the dirty detergent solution from the floor and convey it to the recovery tank. The filter
protects the turbine against the debris and foam. The recovery tank stores the dirty
detergent solution.
The maximum level of the recovery water is given by the inlet hole of the piping coming
from the squeegee inside the tank itself. This hole is located below the end of the
13/08/14 Rev: 2.0.
0 (
TRANSLATION FROM THE ORIGINAL
LANGUAGE)
10