Klark Teknik DN9650, Руководство оператора

Страница: 16 / 50

Chapter 1: Getting Started
DN9650/DN9652 Network Bridge
2 Operator Manual
Handling the equipment
Completely isolate the equipment electrically and disconnect all cables from the
equipment before moving it.
When lifting or moving the equipment, always take its size and weight into
consideration.
Radio frequency interference - Class A device
This equipment has been tested and found to comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the equipment is operated in a
commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the
user will be required to correct the interference at his own expense.
Electric fields
Caution:
In accordance with Part 15 of the FCC Rules & Regulations, “… changes or
modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.”
Should this product be used in an electromagnetic field that is amplitude modulated by
an audio frequency signal (20Hz to 20kHz), the signal to noise ratio may be degraded.
Degradation of up to 60dB at a frequency corresponding to the modulation signal may
be experienced under extreme conditions (3V/m, 90% modulation).
Connecting up the DN965X
Making sure that all equipment is switched off, connect the DN965X to the rest of your
audio equipment, as shown in the following diagrams.
Typical DN9650 audio connection configuration
Third party network
module
DN9650 rear panel
AES50 connectors (for
example, on rear panel
of XL8)
Midas digital console (for
example, an XL8 control centre)
3-port AES50
Video black burst source
Word clock target
Word clock source
Network module A