KITCHENAID
Stand Mixer Service Manual LIT4177310-C 2005 KitchenAid
Fig. 5 The Drip Cup fits tightly and must be started off by
tapping it.
With a 5/32” drift punch, remove the groove pin
that holds the planetary to the vertical center shaft
(Fig. 6).
With the pin out, the planetary can be removed
from the center shaft. Using two (2) screwdrivers,
pry the planetary up and off the shaft (Fig. 7).
F.
Remove the power cord from the bottom cover
by sliding the molded strain relief out of the slot in
the bottom cover (Fig. 8).
To remove the power cord with the Heyco strain
relief used on older models, use a pair of pliers to
squeeze the strain relief while pulling up (Fig. 9).
Reverse this procedure to reinstall it.
G.
To remove the bottom cover from the gearcase-
motor housing, unscrew the five (5) #10-24 special
screws (Fig. 10). These screws hold the internal
gear into the bottom cover.
Next remove the four (4) filister head screws from
the bottom cover (Fig. 11).
Page 4
Fig. 6 Removal of the groove pin that holds the
planetary to the vertical center shaft
Fig. 7 Use two screwdrivers to pry the planetary off the
shaft.
Fig. 8 Pull back on the molded strain relief to remove
the power cord from the slot in the bottom cover.
Fig. 9 Removal of Heyco strain relief using pliers.
