KitchenAid KHWS01PMT / WH, Техническое образование

Страница: 15 / 86

2-7
INSTALLING THE WASHER ON THE PEDESTAL
Excessive Weight Hazard
Use two or more people to move and
uninstall washer.
Failure to do so can result in back or
other injury.
WARNING
IMPORTANT: If the washer is already installed,
it must be uninstalled. See Installation Instruc-
tions that came with the washer for tools re-
quired.
1. Turn off the hot and cold water to the
washer.
13"
(33 cm)
27"
(68.6 cm)
18-9/16"
(47.2 cm)
23-5/8"
(60 cm)
2-5/8"
(6.7 cm)
UNINSTALLING THE WASHER 2. Unplug the power supply cord.
3. Slowly loosen the fill hoses at the faucets
to relieve the water pressure.
4. Remove the “HOT” and “COLD” fill hoses
from the back of the washer. Drain water
in the hoses into a bucket.
5. Squeeze the ears of the drain hose clamp
with pliers to open and slide the clamp
down the hose. Disconnect the drain hose
from the washer and drain any water in the
hose into a bucket.
6. Pull the washer away from the wall so it
can be tipped on its back.
7. Protect the floor with a large piece of
cardboard cut from the pedestal carton.
Lay the washer on its back so that the
cardboard is under the entire lower back
edge of the washer.
IMPORTANT: Check that all 4 pads are
present as shown. If they are not, do not
install the pedestal, and contact your dealer.