14
INSTALLATION
OPERATION
Problem
The shading raises from the sill when the vanes are closed.
Solution
A small gap between the sill and the bottom of the shading is normal in the fully lowered “vane closed” position. The
gap is necessary to allow for the unimpeded movement of the bottom rail.
If this distance is excessive or moves over time, see “Adjust the Vanes Open and Closed Limits” on page 15.
Problem
The shading is hard to raise or lower, or the bottom rail does not stop at the top limit.
Solution
Check that the window is square by measuring the diagonals.
Check that the installation brackets are level. Shim to level, if necessary.
Adjust the bottom rail weight. See below.
Adjusting the Bottom Rail Weight
■
■
Release the weight clips by inserting a flat blade screwdriver into the
weight clip and turning clockwise.
■
■
Move the weight in 1" increments toward the side where the fabric is gathering.
■
■
Secure the weight clips in position by turning them counterclockwise after making the adjustment.
■
■
Test and, if necessary, adjust again.
Problem
The shading is hard to raise or lower, or will not raise or lower.
Solution
Shadings cannot be forced into tight inside mount window openings. If an inside mount, check that the headrail is
installed correctly. Make sure there is clearance between the ends of the shading and the window treatment.
Check that the installation brackets are level and aligned. Adjust and/or shim (not provided) to level, if necessary.
Problem
The shading limits need to be adjusted.
Solution
Adjust the Upper Limit
NOTE:
Programming mode timeout is 20 seconds. If there is no action within 20 seconds, programming mode exits.
■
■
Move the shading to the fully open position (shading is completely inside the headrail). See “Basic Operation” on
page 12.
■
■
Programming mode — In two motions: push the wand up and release, and quickly push the wand up and
hold. After approximately 6 seconds the shading will beep and a red LED behind the activation arm will blink
continuously to indicate the programming mode.
■
■
Release the wand. The upper limit is ready to be adjusted.
■
■
Pull the wand down and release to move the shading down. When the desired upper limit location is reached,
stop the shading. Push the wand up and hold for approximately 6 seconds until the shading moves slightly twice
(down, up). The red LED turns off.
■
■
Release the wand. The shading movement indicates the new upper limit is set and the shading exits programming
mode.
(Continued on next page).
Weight
Bottom Rail
Weight
Clip
Weight
Clip
Fabric Roll
Gathered
Fabric
Move Weight
