15
INSTALLATION
OPERATION
Problem
The shading limits need to be adjusted.
Solution
Adjust the Vanes Open and Closed Limits
Both limits must be set in sequential order when in programming mode.
The mechanical limit is when the shading is at the maximum fully closed (down) position and the vanes have moved
to the open position.
If the mechanical limit is reached while the vanes are being adjusted, the mechanical limit will automatically set the
vanes to the fully open position.
NOTE:
Programming timeout is 20 seconds. If there is no action within 20 seconds, programming mode exits.
■
■
Move the shading to the fully closed (down) position with the vanes fully open. See “Basic Operation” on
page 12.
■
■
Programming mode — In two motions: pull the wand down and release, and quickly pull the wand down and
hold. After approximately 6 seconds the shading will beep and a red LED behind the activation arm will blink
continuously to indicate programming mode.
■
■
Release the wand. The vanes open limit is ready to be adjusted.
IMPORTANT:
For the following step, if you push the wand up, it will set the vanes at the fully open position
(mechanical limit) and then automatically go to the vanes closed position for adjustment.
■
■
Pull the wand down and release to move the vanes to the desired open position. Stop movement when the
desired open position is reached.
■
■
Pull the wand down and hold for approximately 6 seconds until the vanes move slightly twice.
■
■
Release the wand. The vane movement indicates the new vanes open limit is set.
■
■
The shading moves to the vanes closed position.
■
■
Push the wand up or pull to move the vanes to the desired closed vanes position. Stop movement when the
desired closed position is reached.
■
■
Pull the wand down and hold approximately 6 seconds until the shading or vanes move slightly twice.
■
■
Release the wand. The shading or vane movement indicates the new vanes closed, limit is set and the shading
exits programming mode.
