Kirsch Cellular Shade Automation III, Руководство по установке

Страница: 4 / 24

3
INSTALLATION
INSTALLATION
Installation Overview
To install your shade, you will need to perform the following four steps:
STEP 1: Mount the Installation Brackets
STEP 2: Mount the Battery Wand
STEP 3: Install the Shade
STEP 4: Connect the Power Source
STEP 1: Mount the Installation Brackets
■
Your order will include the correct number of installation brackets for your shade width, as shown in the table.
➤
There are two sizes of installation brackets, one for
3
⁄
8
" and
3
⁄
4
" cell sizes and a larger one for the 1
1
⁄
4
" cell size.
➤
For end mounts, only two brackets are used up to the maximum width of 72".
IMPORTANT: A
1
⁄
2
" spacer block is required for shades using an attached battery wand. The spacer block is pre-attached to the
back of the installation bracket.
■
Should the spacer block become detached, reattach it.
➤
Insert the legs of the installation bracket into the tabs on the spacer block.
➤
Rotate the installation bracket back, as shown, to snap it in place.
Mounting Types and Window Terminology
If the installation brackets are mounted correctly, the rest of the installation process follows easily. To prepare for this important
first step, review the mounting types and basic window terminology illustrated below.
■
Refer to the appropriate page below based on your order:
➤
Inside Mount — Below
➤
Outside Mount — P"Mount the Installation Brackets — Outside Mount" on page 5
➤
End Mount — P"Mount the Installation Brackets — End Mount" on page 6
Shade
Width
Brackets
Required
12" – 36" 2
36
1
⁄
8
" – 72" 3
72
1
⁄
8
" – 108" 4
108
1
⁄
8
" – 144" 5
144
1
⁄
8
" – 174" 6
Installation
Bracket
End Mount
Brackets
1
∕
2
" Spacer Block
1
∕
8
" Shim
Tab
Outside Mount
Shade mounts
outside
window opening .
Inside Mount
Shade fits within
window opening.
Collectively, the sill and
jambs are called the
“window casement.”
Molding
Head Jamb
Sill
Jamb Jamb