Kirsch Cellular Shade Automation III, Руководство по установке

Страница: 6 / 24

5
INSTALLATION
INSTALLATION
Mount the Installation Brackets — Outside Mount
■
Center the headrail over the window opening at the desired height. Use a pencil to lightly mark each end of the headrail on the
mounting surface.
➤
Alternatively, measure the width of the headrail and use that width to mark the headrail end points over the window opening.
■
Mark 2" from each end of the headrail.
➤
If more than two installation brackets came
with your order, space additional bracket(s)
evenly between the two end brackets and
mark their location.
Allow a minimum of
15" between the brackets on the right-side
motor end for the battery wand.
Mount
into wood whenever possible.
■
Center the installation brackets on your marks and mark where to drill
the screw holes.
➤
A minimum flat vertical surface of 1
1
⁄
4
" for installation brackets or
extension brackets is required.
➤
The top of the installation brackets or extension brackets should be at
the desired height. The brackets should be level and aligned.
➤
When using extension brackets, mark two screw holes per bracket.
CAUTION: The rear of the brackets must be flush against a flat
mounting surface. Do not mount brackets on curved molding.
■
Drill the screw holes using a
3
⁄
32
" drill bit.
CAUTION: Use drywall anchors when mounting into drywall.
■
Attach the installation or extension brackets using the screws provided.
IMPORTANT: The front edges of the brackets must be level and
aligned to each other.
■
If using spacer blocks, attach the spacer block/installation bracket
assembly to a flat vertical mounting surface with a #6 mounting screw
long enough for a secure installation.
➤
A maximum of 1
1
⁄
2
" of spacer blocks per installation bracket is
recommended. Spacer blocks and shims may be stacked.
➤
Use two
1
⁄
2
" spacer blocks per installation bracket to provide
clearance required for rechargeable battery wand.
➤
A maximum of 1
1
⁄
2
" of spacer blocks per installation bracket is recommended. Spacer
blocks and shims may be stacked.
➤
The top of the spacer blocks should be at the desired shade height.
CAUTION: Use drywall anchors when mounting into drywall.
■
If using extension brackets, attach an installation bracket to the underside of each
extension bracket using the provided screws and speed nuts.
Proceed to "STEP 2: Mount the Battery Wand" on page 6
Minimum of 15" for Battery Wand
Headrail End Marks
Window Opening
2" Space Evenly Space Evenly 2"
Battery
Wand
Rechargeable
Battery Wand