KIRLOSKAR 65-DSM 315M, Инструкция по установке, эксплуатации и обслуживанию

Страница: 88 / 101

IOM/DSMT/001/01 Issue Date: 13/10/2000
Page : Page 9/12 Last Revision Date:
6.4.2 Start the reassembly for non-driving end.
 Insert the casing ring, NDE (190).
 Insert the shaft sleeve (310).
 Insert the bearing cover, NDE (271).
 Press the NDE bearing on the shaft.
 Tighten the bearing nuts. Put appropriate quantity of grease to the bearings.
 Fix the cartridge NDE. The bearing should touch the shoulder provided on
the cartridge.
 Fix the bearing cover to the cartridge by tightening the screws (631).
6.4.3 Now start assembling from driving end.
 Insert the casing ring DE (190).
 Insert the shaft sleeve (310)
 Fit the water deflector (236).
 Insert the bearing cover (270).
 Press fit the DE bearing on the shaft.
 Fix the bearing cartridge DE (241). The outer face of the bearing should
touch the shoulder provided in the cartridge.
 Fix the bearing cover DE to the cartridge by tightening the bolts (631).
 Fit coupling key (321) on the shaft.
This completes the assembly of rotating unit.
6.4.4 Now lift the above rotating unit and fit it properly in the lower half casing so that
pins (610.1, 610.2) take their proper seating.
6.4.5 Fit the two bearing caps by means of bolts. Rotate the whole unit and see that there
is no friction between rotating and stationery parts.
6.4.6 Cut the paper packing to match the profile at the upper and lower half casing. Put
the paper packing (dipped in linseed oil) on the lower half casing. Keep the upper
half casing gently and neatly without disturbing the impellers or packing etc. Insert
the taper pins so that the two halves of the casings will take their proper seat.
6.4.7 Now insert the bolts and nuts for upper half and lower half casing and tighten them.
While tightening the nuts, take care to tighten the diagonally opposite bolts. Rotate
the impeller by rotating driving end of shaft and see that there is no friction between
the rotating unit and stationery parts.
6.4.8 Insert the stuffing box packing staggering the joints in 180° and push each ring
inside as far as possible.