2
1
2. Preparation
(1) Charging the Battery Pack
Plug the AC adapter cable into the
adapter jack located on the rear of
the charger; plug the AC adaptor
into power socket of 220V/50Hz,
and the indicator turns green.
Adjust the mounting bracket of the
charger and slide the battery pack
or the transceiver with the battery
pack into the charger.
Make sure the battery pack contacts
are in contact with the charging
terminals.
The charger LED turns red and charging
begins. The charging time depends on
the battery capacity. After full charging, the charger LED turns green
(Figure 1).
Caution:
If the battery charging is full, do not charge it again. Overcharging will
shorten battery's life or damage it.
After purchasing or extended storage (more than 2 months), the
battery cannot reach its maximum capacity for the first time
recharging. After repeatedly charging and discharging the battery two
or three times, the capacity will reach its normal status.
The charger LED turns off when it detects that the battery has been
damaged within the first 10 minutes of charging.
The charger LED turns off when it is on the protecting status due to
Supplied Accessories
1. Unpacking and Checking the Equipment
ITEM
QUANTITY
Wrist Loop
Belt Clip
Battery
Desktop Charger
Adapter
Instruction Manual
Antenna
Antenna
Carefully unpack the transceiver. We recommend that you identify the
items listed in the following table before discarding the packing mater-
ial. If any items are missing or have been damaged during shipment,
please contact the carrier or dealer immediately.
Adapter
Wrist Loop
Desktop Charger
Battery
Belt Clip
Rotate 180 degrees
Move the mounting bracket
(Figure1)
